Carpenter Model 59 Wire Prefeed & Dereeler
Carpenter Model 59 Wire Prefeed & Dereeler
•
Phone
: (315) 682-
9176 •
Fax
: (315) 682-9160
Website
: www.carpentermfg.com •
Revised 09/27/2021
Page 16
4. With the PN 5333 accumulator pulleys threaded and the upper and lower PN
5549 cams closed, remove the PN 5588 guard assembly by loosening the PN
5584 captive screw. Refer to Figure 11 below.
Figure 11
:
Removing the PN 5588 Guard Assembly
5. Using the PN 8449 drive adjusting knob (shown in Figure 11 above), adjust the
PN 8447 feed belt pair open wide enough so the material may be placed
between each belt.
6. Using the PN 8449 drive adjusting knob, adjust the PN 8447 feed belt pair closed
until both feed belts firmly contact the material.
7. Replace the PN 5588 guard assembly removed in Step 4 above. When
replacing the PN 5588
guard assembly, line up the assembly’s two dowel pins
with the holes on the machine cabinet. Refer to Figure 12 below.
PN 5584
Captive Screw
PN 8449 Drive
Adjusting Knob
PN 8447 Feed
Belt Pair