Owner’s Manual | Model A704-5 Aviation Lighting System
21
© 2008 Carmanah Technologies Corporation
Last revised: April 2008
5.6.2 Entering the PIN
The controller is PIN protected to prevent unauthorized access and control of the A704-5 lights. Before
the controller will operate, a PIN must be entered.
Press 1, 2, 3. As the PIN is entered, the ACTIVE GROUP green LEDs will light to indicate the number
of digits entered.
Press
ENTER.
The PIN STATUS red LED will turn off to indicate the controller has accepted the PIN and is ready to
be used to control A704-5 light(s).
The green ENTER LED will flash once.
123 is the default user PIN. To change this PIN, see section
5.8.1 Changing PINs
.
5.6.3 Autonomous Operation Mode
AUTO is an autonomous setting – when set in this mode, the light(s) will turn on from
dusk to dawn automatically at the selected intensity level. They can be programmed
day or night; however, they will not turn on in the daytime when programmed in the
daytime.
To turn on the light(s) in Autonomous Operation Mode:
Press the AUTO button
Press intensity level LOW, MED, or HIGH
Press
ENTER
A704-5 lights in AUTO Mode located near other lights (within 1 foot) may turn off due to
the light emitted from them.
5.6.4 Temporary Operation Mode
Lights set to temporary high-intensity operation using the controller will remain at this
intensity for 15 minutes before returning to their previously set Autonomous Mode. If a
light is connected to a 12V DC power source and the Temporary Timeout has been
turned off by the push button, the light will stay in the Temporary High-Intensity
Operation.
To turn on the lights in TEMP Mode:
Press the TEMP button
Press intensity level LOW, MED, or HIGH
Press
ENTER
5.6.5 Steady
on
vs. Flash Mode
The FLASH button allows control of Flash Mode in any of the above modes.
To turn on lights in AUTO Mode with flash:
Press the AUTO button
Press intensity level LOW, MED, or HIGH
Press FLASH
Press
ENTER
