This document contains confidential and proprietary information that remains the property of Carlson Software Inc.
Page 1 of 3
Updated 7/24/2014
Carlson Software Inc.
Carlson Software Inc.
Carlson Software Inc.
Carlson Software Inc.
102 West 2
nd
Street
Maysville, KY 41056
www.carlsonsw.com
www.carlsonsw.com
www.carlsonsw.com
www.carlsonsw.com
Phone: (606) 564-5028
Fax: (606) 564-6422
Carlson Mini 2 Geo Cell - 3G Data Modem
The 3G modem is an option for the Mini 2 Geo model
(
It is not included in the Standard model
)
The modem is a cellular data modem, type GSM/UMTS. It is five band modem compatible. The
modem operates in different modes depending on the wireless provider and the signal strength.
Data speeds will vary anywhere from 10 or 20 Kbps when using GPRS to over 1 Mbps when using
HSDPA.
Set up a Data Account with a Wireless Provider
Contact a wireless provider to set up data service for the cellular data modem and obtain an
account and mini SIM card (purchased separately). You need to provide the following
information when setting up an account:
1. Billing Information and business ID such as your Federal Tax I.D. or VAT number.
2. The wireless services required. Specify that you need data service only. You do not need voice
or messaging services.
3. You may be asked for the modem’s IMEI number, which can be found here:
Start > Settings >
System > System Information > 3G Modem
with the modem powered on.
Install the Mini SIM Card
To insert or remove a card follow these steps:
1. Power off the handheld.
2. The mini SIM card slot is located in the battery compartment. Loosen the screws to the door
and remove it.
3. Remove the battery pack.
!
CAUTION:
The Mini 2 i s not sealed against water and dust when the battery door is not
installed.
4. An image on the battery compartment label
shows the correct location and orientation
for the mini SIM card. Pull out the SIM card
tray. Place the card onto the tray and push
the tray in until it catches.
To remove the mini SIM card, pull the tray open
and remove the card. Push the empty tray
in until it catches.
5. Replace the battery pack and attach the
battery door.
6. Power on the Mini 2.
Note: If the modem was on before shutting the Mini 2 down to insert the mini SIM card, you are
prompted to configure the data connection when you reboot.
