ENGLISH
ENGLISH
Positioning and Attaching the Wall Cups
Your gate is a pressure mounted gate. Therefore, it is not necessary to use the screw
attached Wall Cups in your door opening if you choose not to. However, IF YOU ARE
USING THE GATE AT THE TOP OF STAIRS YOU MUST USE THE WALL CUPS. Using the
Wall Cups will affix your gate more firmly in the doorway or opening.
Step 1.
After you have mounted your gate, and you are satisfied with its positioning, use a
pencil or other marking tool to draw a circle on the surface of your doorway or opening
around the perimeter of the 4 rubber feet.
Diagram E
Step 2.
Next, completely remove the gate from the opening by loosening each of the 4
Threaded Spindle Rods and de-pressurizing the gate.
Step 5.
Position the gate so that it is level and centered within your doorway or
opening. Rotate the adjustment wheels on the threaded spindle rods in
the opposite direction as in Step 2, expanding the gap between the
rubber foot and the adjustment wheel.
Expand each of the 4 Threaded Spindle Rods until they make contact
with the doorway or opening. When you are satisfied with the general
placement of your gate, fully tighten the Threaded Spindle Rods. Refer to
Diagram E.
Diagram E
HINT:
It may be necessary to hold the Threaded Spindle Rods or
Rubber Feet while rotating the Adjustment Wheels to ensure
the entire unit does not rotate.
NOTE:
There should be equal spacing among each of the 4 Threaded
Spindle Rods. Make the appropriate adjustment to ensure you
have installed your gate safely.
6
5
