Carl Valentin Spectra II, Краткое руководство пользователя

Страница: 63 / 102

Spectra II
English 63
Loading transfer ribbon
NOTICE!
For the thermal transfer printing method it is necessary to load a ribbon, otherwise when using the printer in direct
thermal print it is not necessary to load a ribbon. The ribbons used in the printer have to be at least the same width
as the print media. In case the ribbon is narrower than the print media, the printhead is partly unprotected and this
could lead to early wear and tear.
NOTICE!
Before a new transfer ribbon roll is loaded, the printhead must be cleaned using printhead and roller cleaner
(97.20.002).
The handling instructions for the use of Isopropanol (IPA) must be observed. In the case of skin or eye contact,
immediately wash off the fluid thoroughly with running water. If the irritation persists, consult a doctor. Ensure
good ventilation.

Open the printer cover.

Open printhead (E) by turning the pressure lever (D) anticlockwise.

Load the transfer ribbon roll (A) with outer winding onto the unwinding roll (C).

Place an empty ribbon roll on the rewinding roll (B) and lead the transfer ribbon below the printhead (E).

Fix the ribbon with an adhesive tape in rotating direction at the empty roll of the rewinding roll (B).
Pay attention to the rotation direction of transfer ribbon rewinder anticlockwise.

In order to move the printhead (E) down, turn the pressure lever (D) in clockwise direction until it locks.

Close the printer cover.
NOTICE!
As for the electrostatic unloading the thin coating of the thermal printhead or other electronic parts can be
damaged, the transfer ribbon should be antistatic.
The use of wrong materials can lead to printer malfunctions and the guarantee can expire.