Carl Valentin COMPA II, Руководство по обслуживанию, Страница: 21 / 66

Compa II series Replacing components
11.15 Service instructions 21
5.6 Replacing the label photocell
NOTICE!
Soiling of the label photocell can also cause malfunctions.
Before replacing the label photocell, check whether it is soiled
and clean it if necessary (see chapter 4.4, page 13).
Figure 11
1. Remove media from the printer.
2. Remove the hexagonal wrench (6) from its retainer.
3. Remove the rear cover of the printer.
4. Slide the label photocell assembly onto the tab (4) toward the rear
cover until it stops.
5. Unplug the cable (2) from the plug on the rear end of the label
photocell (1).
6. Unscrew the screws (5a, b, c) with a hexagonal wrench and
remove the side plate (7).
7. Pull out the label photocell (1) via the tab (4) toward the cover
side.
Compa II 162 + 162 T:
That way the distance plate (3) is pushed
out of label photocell guide.
1. Insert the label photocell (1) into the guide from the cover side and
slide it onto the tab (5) toward the rear cover until it stops.
Compa II 162 + 162 T:
Push the distance plate (3) into the guide
of the label photocell.
2. Remount the side plate (7) with screws (5a, b, c) by tightening the
screws in order, i.e. a, b then c.
3. Connect the cable (2) to the label photocell (1).
4. Pull the label photocell (1) via the tab (4) as far as possible toward
the cover side.
This prevents the cable (2) from being pinched when installing the
rear cover.
5. Install the rear cover of the printer.
6. Insert the hexagonal wrench (6) into its retainer.
7. Adjust the label photocell.
Removing label
photocell
Installing the label
photocell