2
Congratulations on your purchase of the
67”
Yak 54
ARF
. Every effort has been made to
produce a lightweight, straight, easy to assem-
ble aircraft. Because of its oversize control sur-
faces which are double beveled to allow for
extreme throws, great care must be taken in the
set-up and flying of this airplane. Quality hard-
ware components have been provided to allow
for 3D set-up while maintaining adequate
mechanical advantage to eliminate flutter. It is
your responsibility as an advanced pilot to fly
the aircraft in an intelligent manner.
THROTTLE
MANAGEMENT IS A MUST!!!!!!! Carl
Goldberg Products
has flown the
67”Yak 54
ARF
through a very rigorous flight-testing
schedule and have stressed the airframe
beyond all practical parameters without a single
failure.
Carl Goldberg Products
will NOT war-
ranty the
67”Yak 54 ARF
against flutter due to
improper set-up or excessive speed maneuvers.
having said that, we believe you will find the
67”Yak 54 ARF
to be one of the most respon-
sive, in-the-grove aircraft on the market. Just
remember to use common sense when flying
this high performance machine.
We are very proud of the construction of the
67”Yak 54 ARF
and all of our other ARF aircraft.
Each aircraft is jig built to insure a straight true
airframe. Every effort is made to build as light an
aircraft as possible. As with any professional
builder, glue is used sparingly.
Please take a
moment during assembly and run a bead of
CA or aliphatic resin into the high stress
joints that you can reach such as the landing
gear plate, servo mounting trays, wing hold
down blocks, Firewall, etc
. Also, during the
course of shipping from the manufacturer to our
facility in the United States, it is not uncommon
for the aircraft to experience several changes in
climate. This may cause the iron-on covering to
develop wrinkles. This is not a fault of the manu-
facturer. Please take a few minutes with your
heating iron and iron down the seams and re-
shrink the covering where needed. The results
will be a beautiful aircraft with a breathtaking fin-
ish that you will be proud to display at your flying
club.
Before beginning assembly of your
67”Yak 54
ARF
, we highly recommend that you study this
manual in its entirety. You should begin planning
your radio installation based on your choice of
engine and equipment from the beginning.
Because the 67”Yak 54 ARF is intended for
those with some degree of modeling experi-
ence, every minute detail will not be cov-
ered. This is not a basic trainer. Assembly of
this aircraft will be easy for the experienced
modeler, and by following the instructions
within this manual and using the skills
you’ve gained during your modeling career
you will be able to produce a first class air-
craft.
Building supplies needed
Hobby knife w/#11 blades
Thin CA
Medium CA
Canopy glue
30 minute epoxy
Thread lock
Diagonal wire cutters
Pliers
Assorted drill bits
Various sized screwdrivers( both Phillips and
standard head)
Tape measure
Dry-erase marker
Paper towels
Rubbing alcohol
Electrical tape
4-40 Tap & Die Set
3/32, 7/64, 9/64 & 3mm Allen wrench
Wax Paper
3-1 Oil
Note:
Thread lock must be used where
ever any machine bolts are threading
into any type of nuts. If you do not
use thread lock the bolts could
become loose and fall out in flight.
