13
6.
You can bend the pushrod in the plane Make
the 90 degree bend and then cut the remain-
ing wire off leaving a 3/8” length.
With the pushrod reinstall, attach to the servo
output arm and retain with the nylon swing in
keeper.
Depending on the length of your output arm,
you may have to put about a 30 degree bend
in the end of the pushrod to prevent binding.
Operate the servo using your radio and bend
till there is no binding.
7.
Repeat for the other elevator servo.
Rudder Servo Installation
1.
Collect the following parts:
(2) 2-56 clevis
(2) silicon clevis keepers
(2) rigging couplers
(4) brass cable swages
(6-1/2’) braided cable
2.
Take the end of the braided cable and thread
through one of the brass cable swages, then
through one of the rigging couplers.
Loop the cable back through the cable swage.
Take the end and loop it back around the
cable swage and go through the swage again.
