11
NOSEGEAR INSTALLATION
1.
C
OLLECT THE FOLLOWING PARTS
(1)
Nosegear strut
(3) Wheel Collars and set screws
(1) Wheel
(1) Nosegear steering arm
(1) 1.5mm x 43 cm wire and tube
(1) EZ connector and screw
(1) Nylon Swivel Keeper
Cut
2.
Cut one side off the steering arm.
3.
Slide a wheel collar with a set screw onto the
top of the nosegear gear strut.
4.
Insert the nosegear strut thru the hole on the
bottom of the fuselage.
Adjust the strut so that the coil is just off the
bottom of the fuselage.
When satisfied, tighten the wheel collar set
screw.
Holding the strut up inside the fuselage, turn
the fuselage over.
5.
Slide the steering arm on the top of the
nosegear strut.
Tighten the screw in the steering arm as
shown above.
6.
slide the push rod tube through the former
and into the fuel tank compartment.
Insert the 1.5mm wire into the tube.
Make a 1/2” bend in the end of the wire and
insert it through the hole in the steering arm.
Install a swivel keeper over the nosegear
pushrod.
Mount the nosegear wheel just as you did
earlier on the wing.
Pushrod
Connector
Broken View Through
Servo Wheel To Show
Installation
7.
Remove the rudder servo arm.
On the rudder servo arm install the EZ con-
nector in the servo hole next to the center
mounting screw.
Nut
Screw
