9
7.
When satisfied with the fit, glue in place using
thin CA. Apply to both top and bottom and on
both sides of the fuselage. Be careful that it
does not run out of the fuselage and onto the
stab.
6.
Sight the stab from the rear and make sure that
it is parallel with the wing. If required, remove
a small amount of material from the stab sad-
dle to make the stab align with the wing.
5.
Bolt the wing in place using the 4-40 x 3/4”
socket head screw.
8.
Take one elevator half and install two CA
hinges in the pre-cut slots. Locate the hole
for the elevator joiner wire.
Hole for elevator wire
9.
Put epoxy or white glue in the hole for the ele-
vator joiner wire and fit the elevator to the
stab. Use pins in the middle of the hinge to
make sure the hinge stays centered in the
stab and elevator. Leave 1/32” gap at the ele-
vator counter balance.
