7
Flushing out the machine and internal piping/first use
the lights on the control buttons are blinking , blue lights
in used-capsule container is lighted in blue which goes
off after 1 minute .
Tips: you can check easier if the used container is full or
not when the blue light is on.
Plug in the appliance and turn it on.
There are two ways to fill the water tank: directly into the
machine, by
using for example a jug, or by removing the water tank.
Filling
without removing the tank
– raise the water tank lid
– Fill the tank up to the “
MAX” mark with cold fresh water (the
maximum
capacity is
0.8 litre), or at least the “Min” mark .
– low down the lid
Filling
by removing the water tank
–hold the water grip at tilting angle as shown in direction 1 to
remove the water tank from the machine.
– Fill the tank up to Fill the tank up to the “
MAX” mark with
cold fresh water (the maximum
capacity is
0.8 litre). or at least
the “Min” mark .
– slide the water tank slowly on water tank base, when the
water tank outlet is inserted in the inlet receptacle, pushing
firmly on the water grip as shown in direction 2 to lock the
water tank .
1
2
Before using for the first time or after long pauses (e.g.
holidays) the machine must be flushed out. This short
procedure can flush out and cleans the internal piping
thoroughly and remove the residual taste from last brew.
Fill/refill water.
Fill water tank to maximum level.
The indicator will blink in red for first use, meaning the internal circuit is empty.
Please fill up water tank and open the handle, press any button to start pump, once
water is detected entering the internal circuit, the red indicators becomes blue.
Before to start rinsing,make sure that:
– the handle is closed
without
capsule inside.
– the drip tray set is in place.
– a large bowl ( 250ml size or above) is placed under the dispenser.
press the normal espresso button to start flush out, the flush
out process will stop automatically.
– Open the handle to empty brewing chamber.
– Empty the drip tray set.
EN