3
www.carex.com
Before Using your Day
-
Light
Task light, reading lamp, or simply for glare
-
free ambient
light, your Day
-
Light can be used for much more than
light therapy.
1.
Check contents to ensure all parts are enclosed and
in good condition.
2.
Review this guide in its entirety.
3.
Assemble the lamp and test the light tubes.
Complete your Warranty Registration online at
www.carex.com to ensure you are registered.
Contact
your dealer if any product parts are missing or damaged.
Assembling the Day
-
Light
1.
Attach the Weighted Lamp Base (1a
-
1e) to the
Adjustable Height Arm using the screw and
screwdriver.
2.
Lay the Lamp Head with the lens down on a solid non
-
skid surface that will not damage the lens.
3.
Slide the assembled Arm and Base (3a) into the Lamp
Head.
WARNING: The locking tab (3b) must be fully engaged
as shown to prevent the Arm and Base from detaching
from the Lamp Head and causing possible injury.
4.
Fully insert the component plug (4a) and secure the
cord using the 3 clips on the back of the Arm. Plug
into a standard 120 VAC grounded outlet.
1a
FRONT
1c
1e
3a
3b
4a
Day-Light User Guide
1b
1d
Adjusting the Light Mode
High Intensity Setting
-
Therapy Mode
Slide the switch
“
UP
”
and the Day
-
Light emits 10,000
LUX of light at 12"
-
14”
from the lamp. Do not use for
more than 60 minutes per session in Therapy mode.
Low Intensity Setting –
Task/Ambient Mode
Slide the switch
“
DOWN
”
and 5,000 LUX will be emitted
at 12"
-
14”
from the lamp.
NOTE: After switching the Day
-
Light on, it takes about 30
seconds before reaching full intensity.
Adjusting Light Angle and Height
For optimum light therapy , adjust the lamp so that:
•
Lamp head is angled at about 15° from vertical;
•
Eyes face the approximate center of the lamp.
Angle of the Light
To set the angle of the lamp at about
press the silver
button at the top of the Arm, while supporting the Lamp
Head. Release the button at the desired angle.
Height of the Light
Press the lower silver button, while supporting the Lamp
Head. Lift or lower the Lamp Head to the desired height
and release the button.
NOTE: Face toward the Day
-
Light with eyes open during
therapy
-
it is not necessary nor recommended to look
directly into the light.
Eyes should be
positioned approximately
at the center of the lamp
15⁰
3b
