1. Check package contents to ensure that all parts are
enclosed and in good condition (see pictures below).
2. Test light tubes to ensure that all three are in
working order.
Check Package Contents
Your Day-Light comes with the following components:
The light case, which includes three pre-installed
light tubes and a built-in stand on the back;
Two height-adjustable legs (see photo). Note the
placement of the Height Adjustment Button;
Users Guide and your Warranty Registration Card.
Please check to see that all parts are included in your
package. Send in your Warranty Card today to ensure
you are registered.
Contact your dealer if any product
parts are missing or damaged.
Test Light Tubes
Your Day-Light comes equipped with three 36 watt
compact fluorescent light tubes and can be used in a
two-or three-light setting. Test to see that the switch
and light tubes are working properly with these steps:
Plug in the light case.
Push the switch to the solid yellow dot for the three-
light setting. The lamp should illuminate.
Push the switch to the yellow “O” for the two-light
setting. The lamp should illuminate at a lower
intensity.
If all three tubes do not light up, the non-functioning
light may be loose or damaged.
www.day-lights.com
In this event, you will need to remove and reinstall the
nonfunctioning light tube to determine the problem, as
described in the section
Removing and Installing
Day-Light Tubes
below.
Removing & Installing Day-Light Tubes
1. Unplug the Day-Light (remove both detachable legs
if already assembled).
2. Gently lay the lamp with lens down on a flat surface.
3. Remove the nine screws on the back of the unit
using a #2 Philips
screwdriver.
4. Turn the lamp onto its
back. Remove the lens.
5. Check to see if a light
tube is loose. If loose,
remove and re-install.
6. Remove the elastic
around the metal clips.
7. Remove and discard the
rubber shipping insert at
the socket end of the
light tube.
8. To remove the light
tube, depress the white
clip in the middle of the
light housing unit (see
photo). With your other
hand, grasp the tube
near the p
lastic base
and gently wiggle it
until it rises above the
white clip.
9. Twist the light tube until
one side of the base
comes out of the socket.
10. The other side should
slide out with minimal
effort.
11. Now slide out or
disengage the light tube
from the retainer clip at
the other end.
Lens
Switch
Power Cord
Light Case
Removable Legs
Height
Adjustment
Buttons
Knobs
3
Before Using Your Day-Light
