14
INSERTING BATTERIES INTO THE RC
To power the RC, two AA 1,5V batteries are needed. Remove the battery lid by unscrewing the screw on
top of it. Remove the lid. Insert the batteries as shown on the diagram inside the battery container. Place
the lid back on and lock it by tightening the screw.
EN
CAR FUNCTIONS
1. Speed switch
2. Forward/Back switch
3. Music player
4. Remote control
1. The manual rider sits down and switches on the power. Forward/ stop/ back switch
set "forward" , foot pedal switch, car forward, release the foot pedal, car stop. Forward/
stop/ back switch set "back" , step on the foot switch, the car running backwards, release
the foot switch, stop the car. The forward/ Stop/ back switch is in "stop" gear and the car
can not run.
2. The remote control shows that code matching is required for the first time use. The
product has built-in memory, no code matching is required for battery replacement.
2.1 Turn off the body power, hold down the "m" button of the remote control, do not
release, 3 seconds after the first light began to blink, and then release the key.
2.2 At this point to open the body power switch, the remote control of the first light into the
always bright state, the code success.
2.3 When the remote control is not in use 10 seconds will enter the hibernation state,
press any key to wake up.
2.4 Key function description: "/\" forward, "V" backward,
"
<
"
left turn, ">
" right turn, "s" speed,
"p"
brake, press "s" key to set speed, a one light for low speed, two lights for the
medium-speed, three full light for high-speed, reversing only medium-speed. Press the
"P" key
for braking state, all lights should flash, if you want turn off the braking state press “P” again.
1
2
3
4
