8
ENG
“gaSteam HARDWARE” +030220940 -rel. 1.6 - 06.12.2013
2. ASSEMBLY
2.1 Receipt and storage
• Check that the humidifi er is intact upon delivery and immediately
notify the carrier, in writing, of any damage that may be due to careless
or improper transport;
• Move the humidifi er to the site of installation before removing it from
the packaging, holding the neck only from below the base;
• Open the cardboard box and pull out the humidifi er, remove the layer
of protective material and move the humidifi er from the pallet to
the support surface, keeping it vertical at all times; only remove the
protective bag when installing the unit.
F
ig. 2.a
2.2 Positioning and dimensions
• For installation choose the most suitable position for the steam
distribution, that is, the position that minimises the length of the steam
outlet pipe (see STEAM DISTRIBUTION). The unit has been designed for
installation on a fl oor that must be able to support the weight of the
unit in normal operating conditions (see DIMENSIONS AND WEIGHTS).
• The metal casing of the humidifi er heats up during operation, and the
top may reach temperatures of over 50°C (122 °F); check that this does
not cause any problems.
• Make sure the humidifi er is level, and that the minimum spaces are
respected as indicated in Fig. 2.b, to allow room for maintenance
operations.
WARN
I
NG
:
make sure that the cooling fan outlet grill is not blocked or
covered.
1000 mm min.
(40 inch)
1000 mm min.
(40 inch)
1000 mm min.
(40 inch)
1000 mm min.
(40 inch)
F
ig. 2.b
2.3 Removal and reassembly of the front
cover
To remove the front cover of the humidifi er, proceed as follows (
F
ig.
2.c):
1. open the side door A;
2. remove the screws (part V) using a screwdriver;
3. hold cover B by the sides, tilt it until it is released from the side supports,
lift it around 2 centimetres and remove it from the hooks on the side
supports;
4. remove the cover.
To close the appliance, proceed as follows (
F
ig. 2.c):
1. slightly tilt cover B, slide it onto the hooks on the side supports at the
base of the panel;
2. tilt the cover back to vertical, and lightly press it into the side
supports;
3. fasten the locking screws using a screwdriver (part V);
4. close door
A
.
F
ig. 2.c
