Carel ADPB003000, Руководство пользователя

Страница: 25 / 32

pAD +030220873 - rel. 1.2 18.01.2013 27
5. FUNCTIONS
The settings/descriptions of the following functions may
change depending on the application program running on the
controller that the terminal is connected to.
5.1 Device ON/STANDBY
The POWER button is used to start (ON) and stop (PERMANENT or
TEMPORARY STANDBY) the device. The setting is maintained even
when there is no power supply.
pAD does not have an OFF switch; whenever power is
connected, it starts operating. The POWER button simply
starts/stops the temperature and/or humidity control
functions in the area where the terminal is installed.
Procedures required based on the message shown on the
display
pAD in permanent STANDBY
(the display shows OFF)
To enable operation in the previous mode, press the POWER button;
OFF is no longer displayed;
If time band operation was NOT previously activated :
•
time band operation remains OFF;
•
the symbol remains off;
•
operation is activated in the mode previously set using the
mode button;
•
one or more of the following symbols will be on:
.
If time band operation was previously activated (see the paragraph
on “Time bands”):
•
time band operation starts again;
• the symbol comes on
• operation depends on the active time band.
pAD ON - TIME BANDS NOT ACTIVE
(the
symbol is off and the display shows one or more of the
following symbols: ).
To stop the system (PERMANENT STANDBY), press the POWER
button for 3 seconds until the main field on the display shows OFF;
all the symbols will be switched off.
pAD ON AND TIME BANDS ACTIVE
(the
symbol is on)
•
to temporarily activate/deactivate the operation of the
system (ON/TEMPORARY STANDBY, that is, “override”
the time bands), briefly press POWER; one or more of the
symbols - - will come on
(alternatively, all the symbols will go off); the symbol
remains on; when the next switching time is reached (see
the paragraph on “Time bands”), pAD will apply the
corresponding settings to the system;
•
to shut down the system, press POWER for 3 seconds: the
main field displays OFF (PERMANENT STANDBY); the
symbol and all the other symbols will be off.
The possibility to activate cooling in the zone managed and
functions of the buttons depend on the configuration set by
the controller application program.
5.2 Cooling
To activate cooling operation in the zone controlled by the pAD
terminal.
•
Make sure that the system is operating (see the paragraph
“system ON/STANDBY”).
• Press MODE repeatedly until the display shows the
COOLING symbol
.
The possibility to activate cooling in the zone managed and
functions of the buttons depend on the configuration set by
the controller application program.
5.3 Heating
To activate heating operation in the zone controlled by the pAD
terminal.
• Make sure that the system is operating (see the paragraph
“system ON/STANDBY”).
•
Press MODE repeatedly until the display shows the
HEATING symbol
.
The possibility to activate heating in the zone managed and
functions of the buttons depend on the configuration set by
the controller application program.