Carefree Travel'r Arms and Canopy, Руководство по установке

Страница: 11 / 12

Carefree of Colorado Installation Manual T
RAVEL
'
R
052540-002r4 9
TravelR008b
RETRACT
•
EXTEND
•
Carefree of Colorado
Front Rear
Black Red
Ground
+12VDC
Motor Wires
L
N
L
N
Black Black
Red
Red
Detail
A
Wall Mount Connector
A
M
Black
Red
Figure 12. Switch and Wiring.
S
ECURING THE
F
ABRIC
1. Roll the awning in and out several times to make sure that the fabric is square on the rollbar.
2. Secure the canopy using one, #6 x 3/8" hex head screw at both sides of the awning.
Fabric
Alumaguard
1"
#6 x 3/8
Screw
Polyrod
E0014
Fabric
1"
#6 x 3/8
Screw
#6 x 3/8
Screw
Awning Rail Awning Rail Awning Rail Polyrod
Uniguard
Soft Connect
Figure 13. Securing the Fabric.
2.1 For vinyl awnings, place screw through awning rail, polyrod and canopy approximately 1” in from
the end of the fabric.
2.2 For Uniguard awnings, place screw through awning rail, polyrod and the soft connect material
approximately 1" in from the end of the fabric.
2.3 For Alumaguard awnings, place screw on the outer edge of the Alumaguard (not through the
Alumaguard).
R
EMOVING THE
T
EMPORARY
A
SSEMBLY
P
INS
2 pins are inserted into the back of the left (idler) head for lateral stability
during installation. Using a pair of pliers, remove and discard both pins.
NOTE: The awning will temporarily operate with the pins in place;
however, for long term use the pins must be removed.
Remove these
2 Pins
TravelR011
Figure 14. Removing the Assembly
Pins.