Carefree MARQUEE, Руководство по установке

Страница: 8 / 8

M
ARQUEE
Installation Manual Carefree of Colorado
8 052549-001
S
ETTING THE
M
OTOR
L
IMITS
The motor limit switches are preset at the factory for best operation of the awning. The “
OUT
” limit switch is
used to stop the motor when the awning is fully extended. The “
IN
” limit switch is used to stop the motor
when the awning is fully retracted.
The limit switches are located inside the case, near the end cap. It is necessary to extend the awning to
access the switches.
“IN” Limit Switch
“OUT” Limit Switch
View Looking Up from Below Awning
Marquee008
“IN” Limit Switch
“OUT” Limit Switch
LH Motor
Configuration
RH Motor
Configuration
Increase
Decrease
Figure 6. Motor Limit Switches.
Adjusting the OUT Limit Switch
NOTE: During normal operation, the awning will extend out completely then roll back slightly to
provide tension to the fabric.
1. Extend the awning out completely.
2. Confirm that the arms are fully extended. The motor should stop and the fabric should be tight. If the
motor continues to run, the fabric will sag; or, if the motor quits before the arms are extended, it will be
necessary to adjust the “
OUT
” limit switch.
3. Using a 4mm Allen wrench turn the “
OUT
” limit switch. C
LOCKWISE
increases time the motor runs
during extension,
COUNTERCLOCKWISE
reduces the time the motor runs.
NOTE: It is best to make the adjustments in increments of a single turn. 3 full turns of the
screw equals approximately 2” of fabric extension.
4. Extend and retract the awning several times to confirm that the adjustment is correct.
5. Repeat steps 3 and 4 as required until the awning extends correctly.
Adjusting the IN Limit Switch
1. Retract the awning in completely.
2. Confirm that the arms are fully retracted. The motor should stop when the awning is fully retracted. If
the motor continues to run; or, if the motor quits before the arms are fully retracted, it will be necessary
to adjust the “
IN
” limit switch.
3. Using a 4mm Allen wrench turn the “
IN
” limit switch. Clockwise increase time the motor runs during
retraction, counter clockwise reduces the time the motor runs.
NOTE: It is best to make the adjustments in increments of a single turn. 3 full turns of the
screw equals approximately 2” of fabric extension.
4. Extend and retract the awning several times to confirm that the adjustment is correct.
5. Repeat steps 3 and 4 as required until the awning retracts correctly.