Carefree Eclipse 2009, Руководство пользователя

Страница: 5 / 12

E
CLIPSE
5
M
ODE
S
WITCH
OFF ...........................The center position shuts the system down. The awning cannot
be extended or retracted in this mode. The auto-retract system is
also disabled.
CAUTION
I
T IS STRONGLY RECOMMENDED THAT THE POWER SWITCH BE SET TO
OFF
WHENEVER
THE AWNING IS NOT BEING OPERATED AND DURING TRANSPORT
. T
HIS ACTS AS A SAFETY
TO PREVENT THE AWNING FROM BEING ACCIDENTLY OPENED
.
P
OWER
ON .............The bottom position activates the patio switch and provides
power to the awning.
A
UTO
-R
ETRACT
ON ...The top position activates the patio switch and the Auto-Retract
system and provides power to the awning.
When the switch is placed in the POWER ON or Auto-Retract ON position, the
switch will illuminate to indicate the system is active.
P
ATIO
S
WITCH
This is a two position momentary contact switch. This description also applies to
Eclipse models with an exterior switch or any additional patio switches that may
be installed.
E
XTEND
..................Press and release the switch. The awning automatically
opens. To stop the awning before it is open, press and
release the extend switch a second time; or, switch the
MODE
switch to the OFF position.
R
ETRACT
................Press and release the switch. The awning automatically
retracts until it is fully closed. To stop the awning before it is
closed, press and release the retract switch a second time;
or, switch the
MODE
switch to the OFF.
S
ENSITIVITY
S
WITCH
HI ...........................Hi is the least sensitive and responds to winds approximately
equal to 12 mph.
MED ......................Medium responds to winds approximately equal to 9 mph.
LOW ......................Low is the most sensitive and responds to winds
approximately equal to 6 mph.
NOTE: If the sensitivity switch is not installed, the system defaults to the
medium setting.
O
PERATING THE
C
ONTROLS
For Standard operation :
•
Set the
MODE
switch to
POWER ON
or A
UTO
-R
ETRACT ON
.
•
Press and release the Patio Switch to extend or retract the awning.
To activate the Auto-Retract :
•
Set the
MODE
switch to A
UTO
-R
ETRACT
ON and set the W
IND
S
PEED
(sensitivity) switch to the desired level.