PRODUCT CODE
MS01118
P. 14
P. 13
PRODUCT CODE
MS01118
5.6 BATTERY GAUGE
When the key is turned “ON”, the battery gauge will display the battery
power capacity in red, yellow, and green areas respectively.
The green area indicates full battery charge.
The yellow area indicates half battery charge.
The red area indicates low battery charge.
The amount of remaining battery charge displayed on the battery gauge
varies depending on the driving time and driving style.
Repeated starting, stopping, and climbing will consume more charge.
Suggestion
1. If the battery gauge level is in the red area, it is recommended to charge the
battery immediately.
2. After charging or replacing the battery, please ride the scooter for 2-3 minutes
to ensure the battery capacity is sufficient.
3. When driving on an incline, the battery gauge level may change from green to
red as more power is being used.
4. It is normal for battery performance to degrade over time. It is recommended
to replace the battery when the mileage of the battery is approximately 50% of
the mileage of a new unit.
Please contact your dealer regarding your battery. Continuing to use an old
battery with reduced capacity may reduce the maximum travel distance.
5. Power consumption will increase, and mileage will be shortened when going
uphill and downhill regularly.
5.7 ASSEMBLY
No tools are required to disassemble or assemble your scooter.
1. Place the freewheel lever into the drive position.
2. Place the rear section of the scooter into an angled position before attaching the front
section. (Ensure the hooks from the front section are securely attached to the rear
section’s axle).
3. Lower the front and rear section until the scooter is level.
4. Place the battery on the scooter and check that it is secure.
5. Locate the seat onto the seat post. (The swivel lock will engage, and you will hear a click).
6. Turn the key switch to “ON”. (Ensure the battery gauge level shows sufficient power).
Caution
• Ensure all parts are connected properly.
• Before disassembling the scooter, completely switch off the scooter and
remove the key from the key switch to avoid accidents.
• Be careful not to injure your fingers during assembly.
• Before riding the scooter, make sure the front and rear parts are aligned
correctly.
Caution
Assembly, adjustments & disassembly may create trapping hazards.
!
!