CARDIOSTRONG TR70i, Руководство по сборке и эксплуатации

Страница: 14 / 60

TR 70i
14
Adjustment of the running mat
+ During training, the running belt should run as centered and straight as possible.
The alignment of the running belt may change depending on the stress and load.
Another reason can be the positioning of the equipment on an uneven surface.
+ While adjusting the belt, let the equipment run with a speed of approximately
5km/h. Nobody may be on the equipment during this process.
+ If the running belt drifts off to the left, turn the left setting screw on the rear end of
the equipment at most 1/4 rotation clockwise and the right setting screw at most
1/4 rotation counterclockwise (fig. C).
+ If the running belt drifts off to the right, turn the right setting screw on the rear
end of the equipment at most 1/4 rotation clockwise and the left setting screw at
most 1/4 rotation counterclockwise (fig. D).
+ Then watch how the belt runs for approximately 30 seconds, because the change
will not be visible immediately.
+ Repeat the process until the running belt runs straight again. If the running mat
cannot be adjusted, please contact the contract partner.
+ If the running mat (belt) cannot be adjusted, please contact Sport-Tiedje.
Tensioning the running belt again
+ If the running belt slips over the rollers during operation (if this is the case, a
noticeable jerking will be noticed while running), the running belt must be
tensioned again. In most cases, the cause for the slipping is a straining of the belt
through usage. This is completely normal.
+ It can be tightened through the same setting screws that were used during
adjustment.
Move the belt to the right Move the belt to the left