Cardioline HD+, Руководство пользователя

Страница: 9 / 48

HD+
2.
SAFETY INFORMATION
5

No risk has been highlighted from even prolonged contact with the material HD+ Safety Shell and
HD+ Stress Belt are made of. However, it is recommended to avoid direct contact with the skin for
periods exceeding 24 hours.

Using non-specific detergents/disinfectants for cleaning HD+ Safety Shell or HD+ Stress Belt, failure
to comply with the recommended procedures or contact with non-specific materials may cause
additional risks for the physical safety of operators, patients or bystanders or may damage the
device. Do not use strong oxidising agents.

HD+ Safety Shell and HD+ Stress Belt are designed to maintain their features unaltered for at least 3
years. It is recommended to replace the device at the end of its life cycle and in any case, even
before the expiry date should it be damaged or worn.

WARNING: No modification of this equipment is allowed.
Attention

To prevent any damage to the keyboard do not use sharp or heavy objects to press the keys, only
use your fingertips.

The device and the patient cable should be washed before use. Check the connections for any
damage or excessive wear before each use. Replace the patient cable should it present any damage
or be excessively worn.

Do not pull or stretch patient cables as this could result in mechanical and/or electrical failures.
Patient cables should be stored after forming them into a loose loop.

The device will operate exclusively with receiving devices with the appropriate option installed.

There are no user-serviceable parts inside the device. The device can only be dismantled by qualified
service personnel. Any malfunctioning or defective device must be excluded from use and be
checked/repaired by qualified service personnel before being reused.

The use of the device is not recommended in the presence of medical diagnostic imaging equipment
such as the Magnetic Resonance Imaging (MRI) or Computerised Axial Tomography (CAT) in the
same environment.

The following equipment can cause interferences on the RF channel for data transmission:
microwave ovens, diathermy units with LAN (spread spectrum), amateur radio transceivers and
radars.

The device does not require any calibration or special instrumentation for correct use and
maintenance.

When it is necessary to dispose of the device, its components and accessories (e.g.: batteries, cables,
electrodes) and/or packaging material, comply with local standards for waste disposal.

It is well known that the AAA type batteries tend to leak when the device they are inserted in is not
used. If the device is not used for long periods of time, remove the batteries from their
compartment.