PD350MHR
Mechanical Height Rod Installation, Cont.
4.
Align the upper mounting bracket with the holes near the display in the back of the column
and install two (2) M4x10 PM screws to secure the bracket to the column.
5.
Align the holes in the lower bracket with the lower holes in the column and install two (2)
M4x10 PM screws with lock washers to secure it to the column. See Figure No. 18.
(8) M4x10 PM
Screws and
Lock Washers
Figure No. 19
Figure No. 18
6.
Referring to Figure No. 19, place both height rod brackets over the two (2) hex head screws
and pull down, securing brackets. Use included wrench to tighten hex head screws.
Operation
1. Before patient steps on scale, headpiece should
be rotated to horizontal position, and raised we
above patient's head.
ll
ece rests on top of patient's head.
2. Patient may now step on scale.
3. Carefully lower height rod while keeping
headpiece horizontal, until it rests on top of
patient's head. If patient is shorter than 3' 4"
(101.5 cm), push latch to right while
simultaneously pushing down on headpiece, until
headpi
4. Read height of patient as follows:
If back of headpiece points to outer height rod, then
it points to correct height.
If back of headpiece points to inner height rod, then
correct height is read at top of outer height rod (see
"Read" arrow on outer height rod).
A = Latch
B = Headpiece
C = Inner Height Rod
D = Outer Height Rod
E = Measurement
“Read” Line
A
B
D
E
Height Rod in
“rest” Position
C
5. While holding headpiece horizontally, raise it above patient’s head. Patient may now step
off scale.
6. Rotate headpiece back to vertical position and adjust height rod to “rest” position
(headpiece should be locked in place within inner height rod and inner rod should be at its
lowest position).
0044-M380-O1 Rev A
y
ProDoc BFA Series
20
Содержание Detecto ProDoc BFA PD150
Страница 2: ...0044 M380 O1 Rev A y ProDoc BFA Series 2 ...
Страница 8: ...0044 M380 O1 Rev A y ProDoc BFA Series 4 ...
Страница 50: ...0044 M380 O1 Rev A y ProDoc BFA Series 46 ...
