Cardinal Detecto IB-400, Руководство пользователя

Страница: 4 / 12

INTRODUCTION
The Detecto IB-400 Weighmobile provides a fast, easy and efficient method for weighing
bedridden patients. The IB-400 is easily operated by one person. Through its use, patient
weighing time will be reduced to a minimum. Operation of the scale can be quickly learned
using the following instructions and guidelines.
The Detecto IB-400 Weighmobile indicator is a completely self-contained, battery-powered unit
that can be programmed to automatically shutoff after one (1) to nine (9) minutes of non-use. It
can be powered for months by six (6) "C" size Alkaline, Ni-Cad or NiMH batteries and is
equipped with a low "BAT" indicator to alert the operator when the batteries are discharged.
The flame-retardant, anti-bacterial, self-deodorizing Staph-Check® stretcher is non-machine
washable / dryable and should only to be wiped clean using warm, soapy water and/or a mild
detergent and allowed to air dry.
Staph-Chek® is a registered trademark of Herculite Products, Inc.
ASSEMBLY INSTRUCTIONS
1. Unpack and remove all packing material.
2. Check for damaged parts.
3. Install batteries in indicator "C". Refer to the 758C Series Operation Manual,
8555-M167-O1 for detailed instructions.
4. Plug the coiled scale cable from the boom "F" into the 9-pin D shaped connector on the
rear panel of the indicator. Tighten the scale cable connector retaining screws to hold the
cable securely to the connector on the indicator. Refer to the 758C Series Operation
Manual for more information.
5. Pull down on hoop release rings "X" and hang stretcher hoops "J" in hoop brackets "T".
Patient stretcher "K" can now be attached to stretcher support hoop "J".
6. Turn on indicator to check battery charge.
7. Turn the cylinder "H" release valve clockwise to the fullest degree.
8. Move the pump handle "G" up and down slowly until the boom "F" reaches its highest
position.
9. Fully open the cylinder "H" release valve counterclockwise, and push the boom "F" down
as far as it will go.
10. Close the cylinder release valve, turning clockwise.
11. Raise the boom "F" to the approximate height at which it will be used.
2
Reference Figures No. 1 and 2 on pages 4 and 5 for component identification.
It is now time to ready the hydraulic pump assembly: