Cardinal Detecto DR150, Руководство по эксплуатации

Страница: 5 / 8

8525-M275-O1

DR150/400 3
Mounting the Unit
1. Mount bracket to wall using (2) screws
that are appropriate anchors for the
surface being mounted to.
2. Lower control panel into mounted
bracket. Insert flat tip screws (included)
through round holes in mounting bracket
and drive the screws into existing
threaded holes in lower half of control
panel to secure control panel to bracket.
YOUR SCALE IS NOW READY FOR USE.
Display and Function
General Operation
POWER ON
To turn the scale on, press the button
marked “ON”. The display will first show
“
” for approximately two (2) seconds,
then display “ ”. This indicates that the
scale is ready for use.
WEIGHING
When the display shows “ ” it is ready to
weigh an object. If the object exceeds the
capacity of the scale by more than 5%, the
display will show “
oooo
”.
Until the overload condition is reached,
objects can be placed on the platform, with
the display showing the total weight of all
objects on the platform.
TARE OPERATION
To tare (zero out) a load on the platform (i.e.:
the weight of a container), press the button
marked “TARE/HOLD” one time. When this
is done, the display will show the value “
”.
This could be followed by the addition of
another load, if so desired. The display will
show the sum of all additional loads above
and beyond the tared load.
TARE CAPABILITY
A load of up to the capacity of the scale can
be tared (zeroed out).
When a load is tared, an additional load up to
the full capacity of the scale can be weighed.
Example: The Model DR150 has a capacity
of 150 lbs if a load of 20 lbs on that scale is
tared (zeroed out), an additional load or
loads of up to 130 lbs can be weighed.
HOLD OPERATION
With the scale at zero, press and hold the
Tare/Hold button for 2-3 seconds. The
display will prompt “
H on ” or “ H off ”. This
will allow you to toggle between the two
options. With “
H on
” selected, any load on
the scale will continue to be displayed after
the load has been removed. To clear the
weight displayed and return to zero, press
the Tare/Hold again. With “
H off
” selected,
the scale display will not show (hold) the
weight after the load has been removed.
NOTE! The “
H on
” must be selected each
time the scale is turned on.