2
Mounting Foot
Locking Nut
INSTALLATION
On receipt of your AS-400D series scale, carefully unpack the scale removing all packing
material. Examine the scale to make certain there is no shipping damage. Should damage be
discovered contact the shipping company as soon as possible. The packing material and
shipping carton should be retained for possible examination by the shipping company.
Determine where the scale is to be located. It should be a smooth surface capable of
supporting both the scale and any load apt to be placed on the scale. It should not be in direct
sunlight nor should it be subject to air flow from heating/cooling vents, fans or similar devices.
Place the scale in the chosen location and remove the stainless steel platform. The platform
can be removed by lifting upward on it removing it from the weighbridge. Locate the small
level indicator on the weighbridge and check to make certain that the scale is level. If the level
indicator does not show a level indication, the mounting feet should be adjusted to obtain a
level condition. To adjust a mounting foot, first loosen the lock nut then turn the mounting foot
in the required direction to raise or lower that corner of the scale. Once a level condition has
been achieved, secure the mounting foot settings by tightening each of the lock nuts. Replace
the platform on the weighbridge.
Plug the power cord into a 115/120 VAC grounded polarized power outlet, making certain that
the power cord is not in the way of normal traffic.
If you are unsure whether your power outlet is correct, you should consult a
qualified electrician.
Plug the power cord into the power receptacle on the rear of the scale base. If the display
illuminates with a display segment test, installation of the scale is complete. If not, check to
make sure that the power outlet and the scale fuse are good.
NOT
LEVEL
LEVEL
Bubble
is
not
Bubble
is
within
circle
within
circle
