Cardinal 2XX-EIP, Руководство по установке

Страница: 11 / 20

8200-M554-O1
x
2XX-EIP
Page 9
COMMUNICATIONS
Data Sent From The Indicator To The PLC:
Float point weight. Byte 0 Float point weight. Byte 1 Word0
Float point weight. Byte 2 Float point weight. Byte 3 Word1
PWC status. Bit0 = PWC1... 1=on Weight status. See bit definitions below Word2
Cmd1. Returned by the indicator when
complete
Cmd0. Returned by the indicator when
complete
Word3
Data Sent From The PLC To The Indicator:
Cmd1. See definition below Cmd0. See definition below Word0
N/A N/A Word1
Float point value for Cmd. Byte 0 Float point value for Cmd. Byte 1 Word2
Float point value for Cmd. Byte 2 Float point value for Cmd. Byte 3 Word3
WEIGHT STATUS (Data[4])
Bit0 MOTION
Bit1 BELOW ZERO
Bit2 CENTER OF ZERO
Bit3 OVER CAPACITY
Bit4 WEIGH UNITS 0=unit1 (lb)/1=unit2 (kg)
Bit5 WEIGH MODE 0=Gross/1=Net
Bit6 Not defined
Bit7 Scale Error. The indicator has failed to communicate for at least 3 seconds,
data is invalid.
PWC STATUS (Data[5])
NOTE! The following status section applies only if the PWC has been enabled. Refer to the
Technical and Installation manual of your indicator for instructions on enabling and using the
PWC feature.
Bit0 PWC1 0=off/1=on
Bit1 PWC2 0=off/1=on
Bit2 PWC3 0=off/1=on
Bit3 PWC4 0=off/1=on
Bit4 PWC5 0=off/1=on
Bit5 PWC6 0=off/1=on
Bit6 PWC7 0=off/1=on
Bit7 PWC8 0=off/1=on