CARBONE TIG160PDCHF, Руководство оператора, Страница: 19 / 38

B-5 OPERATION B-5
12.REMOTE RECEPTACLE
*note
(OR argon arc
control)
Provides for connection of remote control and/or
arc start switch in TIG Mode: Plugging a remote
current control (Adjustable foot control) into this
receptacle automatically switches the output control
from the panel Max Output Control (See Item 3) to
the remote control.
The connected remote control will then control
the output current between the Min. range of the
machine and the setting of the panel Max Output
Control.
13. output"+"
（ Electrode Connection (Positive) ）
For quick disconnect system using Twist-Mate
cable plugs
14.output"-"
（
Electrode Connection (Negative)
）
This quick connect Twist-Mate receptacle provides
electrical connection to the electrode holder and
cable for Stick welding and connection for the TIG
torch when TIG welding.
15. argon out
connected gas pipe of torch
17.fan
when power switch on, the cooling fan runs
18. power supply
connected main supply
19.Pulse On/Off.
Press the touch-pad button to select the desired
pulse mode.
20.MMA/TIG switch (MODE SWITCH)
Select the mode of output
21. DIGITAL METER -
A 3 digit LED meter is
used to display the preset output current level
before welding, and actual output level while
welding: A lit display indicates input power is turned
on. (See Item 1.)
22.indicating light of over heat
-If the welder overheats due to blocked air flow,
high ambient air temperature, or exceeded duty
cycle, an internal thermostat will open disabling the
welding output and this yellow light will illuminate.
The cooling fans will continue to run to cool the unit
during this time. The light will go out when the unit
cools and the thermostat resets. Once the light
goes out, the machine will again become available
to weld.
*note
：
nameplate
T
he data plate stamped on the metal structure
complies with the EN 60974-1,
EN50199(EN60974-10) international standards and
contains the following information:
* (a) Manufacturer's name and address
* (b) Trademark
* (c) Model
* (No) Serial number
* ( ) The welding power
source comprises a frequency converter followed by
an transformer and rectifier that transforms input
voltage into direct current.
* (EN 60974-1/EN 50199) Standards applied.
* ( ) Direct current.
* (x) Utilisation factor expressed as a percentage of
useful work over a cycle of 10 minutes at an
ambient temperature of 40
o
C.
* (I
2
) Rated weld current.
* (U
2
) Conventional load voltage.
* (Uo) Rated no-load voltage.
* ( ) TIG welding.
* ( ) MMA welding.
* ( )) 1input phases.
* (IP21S) Casing protection degree in compliance
with the EN 60529 Standard:
IP2XX Casing protected against access to
dangerous components with fingers and against the
introduction of foreign matters with diameter 12.5
mm.
IPX3X Casing protected against rain failing at
60~on the vertical line.
IPXXC Casing protected against contact of a test
gauge
φ 2.5 mm length 100 mm with live
dangerous parts,
* (U
1
) Rated power supply voltage.
* (50/60 Hz) Power supply rated frequency.
* (l
lmax
) Maximum supply current.
(I
1 eff
) Effective supply current.* ( S ) Generator
suitable for installation in places where major risks
of electric shocks are preset
* (CE) In compliance with the European regulations
in force.
~
1~
f1
f2 ~