CARBONE DIGI-CUT70, Руководство оператора, Страница: 14 / 33

A-6 INSTALLATION A-6
ENGINE DRIVEN GENERATOR
The Inverter machine can be operated on engine
driven generators as long as the 220/230/240 volt
auxiliary meets the following conditions:
. The AC waveform peak voltage is below 400 volts.
. The AC waveform frequency is between 45 and
65Hz.
The following Lincoln engine drives meet these
conditions when run in the high idle mode:
● Ranger 250,305 ● . Commander 300, 400, & 500
Some engine drives do not meet these conditions
(e.g. Miller Bobcats, etc). Operation of the Inverter
machine is not recommended on engine drives not
conforming to these conditions. Such drives may
deliver unacceptably high voltage levels to the
Inverter machine power source.
The available output current of the Pro-Cut 80 may
belimited due to the output capacity of the engine
drivenpower supply. The following are
recommended outputcurrent settings when used
with various Lincolnengine driven power supplies.
CONNECTIONS FOR CUTTING
WORK CABLE CONNECTION
Next, connect the work cable to the
“
+
”
output
terminal in the same way.
To minimize high frequency interference, refer to
Machine Grounding and High Frequency
Interference Protection section of this manual for
the proper procedure on grounding the work clamp
and work piece.
CYLINDER could explode if damaged.
Keep cylinder upright and
chained to a support.
Keep cylinder away from areas
where it could be damaged.
Never allow the torch to touch the
cylinder.
Keep cylinder away from live electrical circuits.
Maximum inlet pressure 150 psi.
A cylinder is loaded by leaning it slightly sideways
and rocking it up on the platform, being careful not
to allow the Under-Storage Cart to roll. Secure the
cylinder in place with the provided chain. Unload by
following these steps in reverse.