Carba-Tec CTH-110L 1PH, Руководство пользователя

Страница: 15 / 32

Mounting Rail and Fence
Assembly
With the extension wings properly aligned, the rail
and fence assembly can now be mounted to the
saw.
1. Attach the rear fence support (the ‘c’ section rail) to
the back of the saw assembly using the 4 bolts
provided. Two bolts will thread into the holes provided
on the rear of the main saw unit, and two bolts are
attached to the LH and RH extension wing with the
supplied nuts on the inside. See Fig. 23
The holes in the rear fence support are slotted for
adjustment. Keep the rail as low as possible to ensure
the mitre gauge will clear the fence rail.
2. Attach the front fence support rail (the angle
section) to the front of the saw assembly using the 4
bolts provided. All four bolts attach to the main saw
unit, LH and RH extension wing with the supplied nuts
on the inside. See Fig. 24
3. Attach the main front fence rail to the front fence
support rail using the 3 cap screws and washers
supplied.
4. Attach the RH extension table (the composite
board in the metal frame - (A) in Fig. 24), to the RH
side of the saw, mounting it between the front and rear
fence rails with the 6 bolts, nuts and washers (3 in
front rail - 3 in reay rail).
5. Mount the switch assembly to the underside of the
front fence rail. There are threaded holes provided on
the LH side. Use the 2 small bolts and washers
provided.
6. Ensure all rails are level, and tighten all bolts and
nuts.
7. Attach fence assembly to the saw by lowering it
over the front fence rail. Make sure the flat clamp
plate behind the locking lever runs between the lever
and the front of ther rail.
www.carbatec.com.au
Assembly Instructions
15
Fig.23
Fig.24
Fig.26
A