Car-O-Liner Group AB
B73 and B731 Clamping and Support systems
12
50094, EN - rev. 0, 2020-03
3.2 Vehicle Setup Procedure for the Clamping and Support System
NOTE
! Vehicle Setup Procedure described below is applicable for BenchRack.
For Mark6 and Quick42 set up,
see separate instruction manuals.
BenchRack
Front axle member and rear axle are recommended lifting points.
1. Position the pillar jacks under the lifting points. Tighten the pillar jacks to the bench.
2. Lower the lift carefully to raise the vehicle from the ramps to allow the bench mountings
and rear chassis clamps to be fitted.
3. Remove the side ramps from under the rear wheels. Raise the bench carefully so that
the chassis clamps are correctly positioned.
4. Remove the pillar jacks from the rear. Position them at the front lifting points and repeat
the procedure.
Pillar jacks
Clamps
Bench mounting
