Version 14.06..2018
HW: LVDS
CI-VL2-PCM31
P
a
g
e
15
2.9.
Connecting video-interface – analogue
If the communication between the CAN box and the vehicle’s CAN bus does not succeed (not
all vehicles are compatible), an analogue connection is required by using the 6pin cable with
open wire ends.
Connect the female 6pin connector of the 6pin cable to the 6pin connector of the
video interface.
Connect the yellow, the red and the black wire of the 6pin cable to the vehicle’s
power and ground.
Note:
The connection of the green wire (Reverse signal) will be described in chapter “After-
market rear-view camera”. The white wire will be used to switch the enabled video sources
(see chapter “video interface – operation”). The grey wire stays unconnected.
