Version 08.04.2021
HW CAM(V31)/(V22)
CI-RL2-RLINK
P
a
g
e
9
2.4.
Installation of the Ribbon cables into the Monitor panel
Remove the factory monitor and open it`s housing. The external daughter PCB is built to be
installed into the optical lead between the monitor panel and mainboard of the vehicles
monitor. The daughter PCB is equipped with to different ribbon cable options to support two
different monitor systems. Both 50pin Ribbon cables and both 60pin Ribbon cables are easily
recognizable, as they differ in size. Depending on the system, the two unneeded ribbon
cables have to be removed by unclipping the Ribbon cable base.
Connect the female 20pin connector of the daughter PCB to the male20pin connector
of the picture signal cable and connect the second male 20pin connector opposite
the cable to the female 20pin connector of the interface. Take care for installing the
cable in the right direction as both connectors seem to be identical. (Take notice of
the wire`s caption “
MONITOR SIDE
” and “
BOX SIDE
”
