Version 08.04.2021
HW CAM(V31)/(V22)
CI-RL2-RLINK
P
a
g
e
8
2.3.
Connecting video-interface and CAN-Box
The CAN-box reads digital signals from the CAN-bus and converts them for the video-
interface. ACC +12V max. 0.5A (red of 6pin) and reverse gear +12V max. 0.5A constant signal
(green of 6pin). Video-source switching (white of 6pin) as +12V impulse. The grey wire stays
unconnected.
Connect the white female 6pin connector of the 6pin to 8pin cable to the male 6pin
connector of the video-interface.
Connect the black female 8pin Micro-Fit connector of the 6pin to 8pin cable to the
male 8pin Micro-Fit connector of the CAN-box.
Note:
Check LEDs on video-interface after reconnecting the battery, one must be on.
Connect the black female 4pin connector of the PNP Power 7 CAN cable to the 4pin
Micro-Fit connector of the CAN-box.
Note:
Check LEDs on CAN-box after reconnecting the battery, two must be on.
Note:
The CAN-box is not compatible to all vehicles. If the CAN-box does not deliver ACC to
pin2 of the video-interface or blocks the vehicle CAN, it is possible to install the system
without CAN-box. In this case, see also the note in chapter “after-market rear-view camera”,
how the interface is supposed to be connected without CAN-Box.
