Version 03.05.2021
HW: BOT(V40)(V54)
CI-RL4-NAC12
P
a
g
e
9
1.5.6.
Activating the factory PDC display (Dip-8)
Dip 8 is used to activate the factory PDC display (if available) when retrofitting an after-
market rear view camera. When dip switch is set to
OFF
, the factory PDC display is shown on
the right side of the display. With Dip switch position
ON
, the factory PDC display is not
shown.
Note:
Dip 7 is out of function and has to be set to
OFF
.
After each Dip-switch-change a power-reset of the interface box has to be performed!
1.6.
Settings of the 4 Dip switches (CAN function - red)
In contrast to the 8-dip switches
dip position
up = ON
and position
down = OFF
!
After each Dip-switch-change a power-reset of the Can-box has to be performed!
2.
Installation
Switch off the ignition and disconnect the vehicle’s battery! The interface needs a
permanent 12V source. If -according to factory rules- a disconnection of the battery has to
be avoided, it should be sufficient to use the vehicle’s sleep-mode. In case, the sleep-mode
doesn’t succeed, the battery has to be disconnected with a resistor lead.
The Interface needs a permanent power supply! If power isn’t directly taken from the
battery, the connection’s power has to be checked for being start-up proven and
permanent.
Before the final installation, we recommend a test-run of the interface. Due to changes in
the production of the vehicle manufacturer, there’s always the possibility of
incompatibility.
2.1.
Place of installation – video-interface
The video-interface is performed to be installed at the head unit’s rear side.
Monitor size
Dip 1
Dip 2
10.25
OFF
ON
