Version 01.12.2021
HW: CAM(V100)/(V52)
CI-RL4-NAC08
P
a
g
e
22
2.7.
Picture settings and guide lines
The picture settings can be adjusted by the 3 buttons on the video-interface. Press the
MENU
button to open the OSD settings menu. To switch to the next menu item, pressing
UP
and
DOWN
will change the selected value. The buttons are embedded in the housing to
avoid accidental changes during or after installation. The picture settings have to be done
separately for AV1 and AV2 while the corresponding input is selected and visible on the
monitor.
Note:
The OSD menu is only shown when a working video source is connected to the
selected video-input of the interface.
The following settings are available:
Contrast
Brightness
Saturation
Position H
horizontal picture position
Position V
vertical picture position
IR-AV1
(out of function)
IR-AV2
(out of function)
Guide-L
Guide lines position
Guide-CNTRL -
Guide lines for
rear-view camera /PDC
H-SIZE (horizontal)
horizontal picture size RVC
V-SIZE (vertical)
vertical picture size RVC
The menu’s point „UI-CNTRL“ does support the
guide lines options like shown beside:
Note:
If, when adjusting the guide lines (L/R), the lines do not move despite a change in
value, the change can be seen after disengaging and re-engaging the reverse gear.
Note:
If the vehicle’s CAN communication does not support the video interface, the guide-
lines cannot be used, even if they’re once shown with the first operation!
Options:
All ON
: Guide lines and PDC will be
displayed.
PDC ON
: Only PDC displayed.
Guide ON
: Only Guide lines displayed.
ALL Off
: Guide lines and PDC will not
be displayed.
