Version 28.05.2015
RL-LR12-TF
Pa
ge
3
1.3.
Setting the dip switches of the CAN-box TV-400/500
TV-400
Note:
Setting dip 1 to ON codes the factory rear-view camera input which is located on the
6pin male connector of the factory monitor. When reverse gear is engaged, the navigation
will automatically switch to this input.
TV-500
Vehicle/ navigation
Dip 1 Dip 2 Dip 3 Dip 4 Dip 5 Dip 6
Video-in-motion permanent
ON
ON
OFF
OFF
ON
ON
Video-in-motion selective*
OFF
ON
OFF
OFF
ON
ON
* With dip1 to OFF the included green cable is used to activate the video-in-motion function
Note
: Dip switch functions of the TV-500
Dip 1 – activation TV-free
Dip 2 – rear-view camera existing
Dip 3 – TV icon simulation
Dip 4 – no function
Dip 5 – CAN-bus termination resistor on the vehicle side
Dip 6 – CAN-bus termination resistor on the head-unit side
Setting dip 2 to ON codes the factory rear-view camera input which is located on the brown
Fakra male connector of the factory monitor. When reverse gear is engaged, the navigation
will automatically switch to this input. On vehicles with factory rear-view camera set Dip 2 to
ON, too.
Alle vehicles
dip 1 ON, dip 2 ON, dip 3 ON
Содержание CI-RL-LR12-TF
Страница 5: ...Version 28 05 2015 RL LR12 TF Page 4 ...
