CAR-connect LDC.22-500, Руководство по эксплуатации

Страница: 26 / 56

Operation
26 41.CC.2210.3042_BA_V00_EN
A safe and suitable power supply connection that complies with the applicable standards
is required to ensure that the traction battery can be charged safely.
The following illustration of a power supply connection is provided as an example and may
differ from your particular situation. This has no effect on the steps to be performed.
(1) Miniature circuit breakers
(2) Three-phase power supply connection
(3) Residual-current device (RCD)
Carry out the following inspections to check the power supply connection:
1. Always check the general condition of the electrical installation. Check the condition
of the three-phase power supply connection and the Schuko sockets.
2. Check that the miniature circuit breakers and the residual-current device comply with
the product specifications (see chapter “Technical data”).

You cannot operate the product on this power supply until all the checks have been
performed successfully.
5.2 Startup
This section provides you with information about starting up and operating the product.
CAUTION
Tripping hazard!
Tripping over exposed cables or the housing may result in physical injury!
• Warn other persons about exposed cables and the housing!
•
Never block traffic or escape routes!
•
Position the vehicle next to the power supply!
• Ensure that persons do not enter the area where the product is being used without
due care!
•
Take special care when entering the area where the product is being used!