P 5555 / GH-190
ELECTRIC RAT KILLER EN
Warning: Please read this instruction manual carefully before using the instrument and keep
it for future use.
A.
FEATURES
Material : ABS
Power : 4 type C LR14 batteries (not included) or adaptor included in this pack
Voltage : 7000 V
B.
HOW TO USE IT
WARNING: If you have small children or pets place the rodent trap at locations
that are completely inaccessible to them (For example in a room locked by a key,
at a height which is inaccessible to them, or behind a furniture if you are certain
that they will not be able to reach the device)
Do not take any risk, the device emits electric shocks of 7000 volts!
Use inside only, do not use outside (do not resist to rain):
-
Either with adpator included
-
Either with batteries (if socket is too far away from where you want to use the
trap or if you want to use it in barns, garage, under stairs, shelter etc)
Before to plug it remove the batteries.
1)
Use DC 6V adaptor
Plug the device using the QC adaptor included. Make sure that the cable runs along the walls
to prevent someone from getting in and falling.
If the place where you want to place the rodent trap is too far from a power outlet, use
batteries instead of the AC adapter.
2)
Insert or replace the batteries
Open the battery compartment on the top of the device and insert 4
batteries type C observing the polarity.
Replace the battery comprtment cover.
3)
Place the bait
Place the bait through one of the bottom hole on the back plate :
small piece of cheese, peanut butter, bacon, or any other dry food
or nuts. Use a Q-tip or toothpick to avoid to transfer human smell
on the trap.
4)
Install the device
Identify location with rat activity, look for worn trails or walkays.
Place unit on the floor against wall, the entrance in-line with the trail
rats prefer to travel against a wall.
5)
Start the device
Press the switch to ON position. Unit will hum and the green light
will flash, then the red light will flash every 5 seconds indicating that
the unit has been enabled. To prevent shock, avoid contact with
metal plates . Do not touch the bottom of the machine.
Leave the trap in place for at least one full day and night or even longer.
The rat triggers metal plate when rodent enter the unit, and the unit emits
high voltage shock immediately , the red light flashes.
High voltage produce time is 4 minutes : it delivers high voltage for 1 minute,
later impulse electric-shock which imitating rat heartbeat 15HZ for each time
and it continues for 3 minutes, then the high voltage shock stops, the light
turns from red to green and flashes every 5 seconds. Here, high voltage
shock will not be produced until restarting the unit next time.
Press the switch OFF and un-plug if used through DC adaptor.
To throw the rat, simply put it in the trash without needing to see it or
touch it. Let it dry on the sun and clean it. The trap can then be reset
and reused. To reset it, place a new bait, set the trap and turn it on as
instructed above.
When low battery, the red light flashes. Press the switch OFF and
replace battery as explained on B-2)
C.
CARE AND MAINTENANCE
WARNING: If you have kids or pets, place this trap out of reach from them ( for
example in a room closed and locked with a key or in a place very high that they
can’t reach)
