BEFORE USING FOR THE FIRST TIME
Read all Important Safeguards and Operating Instructions before using
this kettle. Discard the first filling of boiling water to remove any dust
and residues from the manufacturing process.
1. TO BOIL WATER (default setting)
1. Remove kettle from base.
2. Push the button on the lid (Fig. 1A). The lid opens itself.
3. Fill with the desired amount of fresh cold water. The kettle has
minimum and maximum markings. Never underfill or overfill the kettle.
CAUTION / DANGEROUS:
Never fill above the MAX line. If you fill
above the max line, boiling water will push out of the pouring spout.
This can cause severe injuries and burns.
4. Close lid.
5. Place kettle on Power Base (Fig. 1G).
6. Plug cord into outlet. The display illuminates and shows the kettle
symbol and 212ºF (Fig. 3a).
7. Push the On/Off button (Fig. 2d). The kettle symbol will blink, indicating
that the kettle is heating the water. The warmer the water becomes
the more you will hear the noise of the water heating up.
8. When the water comes to a boil the display will switch from the kettle
symbol to the timer symbol (Fig. 3d). The timer symbol will blink for
three seconds (default). Then the display changes back to the kettle
symbol (not blinking) and the heater shuts off.
9. Lift kettle from base and pour water out slowly. For different settings
see chapters 4, 5 and 6.
2. DRY BOIL SHUT-OFF PROTECTION
If you turn the kettle on without water in the kettle, the heater will shut
off after a few seconds. The display will go blank. Once the kettle has
cooled down, the display will come back on again. This can take several
minutes. To speed up this process you can fill some cold water into the
kettle. You will hear a clicking noise. This indicates that the thermostat
has reset itself. If you place the kettle back on the power base, the
display will show the default setting again (Fig. 3a).
Please note:
AUTO-OFF. The kettle will always shut-off after the selected
temperature has been reached.
6.
