Caple WC6400, Руководство по обслуживанию

Страница: 19 / 27

19/27
After removing the air-duct board
（
6.1.2.
）
, the heater is on the back of it, remove the fixing
screws and we can remove the heater. （ Fig.10 ）
6.1.7. How to remove the defrost sensors
The process: Remove the shelves → Remove the control panel film → Remove the screws →
Remove the display supporter → Remove the middle electrical box → Remove the upper
air-duct board → remove the sensor cover → remove the sensors
1. How to remove the defrost sensor and upper compartment sensor.
Remove the upper air-duct board(A)
（
6.1.2.
）
, pull out the two expanding nails(D) by pressing
from rear with hard tool, the sensor cover(C) loose, pull out the sensor (B).
(Fig.11)
2.
How to remove the lower compartment sensor
The process: Remove the shelves → Remove the lower air-duct board → remove the sensor
Remove the shelves, remove the lower air-duct board, we can see the lower compartment sensor, remove the
sensor fixing screw and remove the sensor
(Fig.7)
6.1.8 ． How to remove the LED light.
1. How to remove the lower compartment LED light.
The process: Remove the shelves → Remove the control panel film → Remove the screws →
Remove the display supporter → Remove the PCB
①．
Remove the shelves, peel off the control panel film, remove the middle electrical box. ( Fig.2&
Fig.3 &Fig.4)
②．
Disconnect the connector, press the head of the nails one by one, pull the light PCB upward,
Screws
Heater
Back of the
inner air-duct
board
Fig.10
Fig.11