Instruction manual WC1800
18
19
Please keep this instruction manual for future reference
Instruction manual WC1800
Please keep this instruction manual for future reference
NOTE:
The furniture door can extend beyond the appliance door, however you must ensure a gap of at
least 75mm must be left from the bottom of the furniture door to the floor to allow for sufficient
ventilation.
NOTE:
If a handle is required, please ensure this is installed in an appropriate position before the
furniture door is installed.
1. Fully open door.
2. Starting at the corner, pull the gasket away from the door (see Fig. A - pg 19).
3. Continue to pull the gasket free from the gasket channel.
4. Upon removal, lay gasket down on a flat surface.
5. Secure the furniture door panel to the appliance door using clamps (see Fig. B - pg 19).
6. Using a 3mm drill bit, drill 10 pilot holes into the wood panel 12mm deep using the holes in the
door frame as a guide.
NOTE:
It is important to ensure that all drilled holes are drilled to the correct depth in order to avoid
splits in the wood when hardwood is installed. You must also take care not to drill all the way
through the door.
7. Locate 10 of the M4x34mm screws provided with your unit.
8. Using a Phillips screwdriver, place one screw into each of the 10 pilot holes and screw into
the door (see Fig. C - pg 19). Be careful not to over tighten screws. Ensure the screws sit flush
against the bottom of the channel. Remove clamps from door.
