Caple SL EM903-P, Руководство пользователя, Страница: 20 / 26

15
The LED on the right side will start to flash
(every 5 seconds), the hood will work for 10
minutes at the selected speed and then it li-
ghts automatically off.
If the client increases or reduces the speed
while the timer is on, this is automatically
stopped.Standard configuration If two coo-
kerhoods-radiocontrol system are installed in
the same room or in the immediate vicinity,
each system may affect the operation of the
other, due to the fact that they have the same
code.
Therefore it will be necessary to change the
code of one of the radio controls.
Warning: The battery should be replaced
every yearto guarantee the optimal range of
the transmitter.
To replace the exhausted battery, take the
plastic lid off, remove the battery and replace
it with a new one, ob-serving the correct bat-
tery polarities.
Used batteries should be discarded in special
collection bins.Generating a new transmission
code The radiocontrol is supplied by the ma-
nufacturer with default codes stored. If you
want to create a new set of codes, proceed
as follows:press and hold the UP, STOP and
DOWN but-tons simultaneously for 2 secon-
ds. Afterthe LEDS light up, press the UP and
DOWN button swithin 5 seconds. The LEDS
will flash 3 times to indicate that the process
is completed.
WARNING: This procedure deletes all pre-
viously stored codes. Learning the new tran-
smission code After changing the transmis-
sion code on the radio control, the cooker
hood electronic control unit must be made to
set the new code as follows : press the main
Power Off button on the cookerhood and then
restore power to the electronic control unit.
The power off button can be seen after remo-
ving the grease filter.
Within the next 15 seconds, press the Light
button . This will ensure the control unit
is synchroni-zed with the new code.
TIMING
As a result of the new EU65 “Energy label” and
EU66 “ Ecodesign” regulations issued by the
European Commission, which came into force
as from January 1st, 2015 , our products have
been adapted to comply with these new re-
quirements.
All of the models complying with the energy
label requirements, are equipped with new
electronics including a timer device for suction
speeds control, when the air capacity exceeds
650m³/h.
Internal motor models, with maximum air
capacity higher than 650m³/h, are equipped
with a timer device that automatically switches
the suction speed from 4th to 3rd speed, after
5 minutes operation.
External motor models are equipped with re-
mote motors that , as for internal motor ver-
sions, include a timer device that switches
down the suction speed when it exceeds 650
mᵌ/h. (See External Motors Instructions ).
Remote motors, whose air capacity exce-
eds 650m³/h at both 4th and 3rd speed, will
have the following by default timer control
functions: The suction speed is automatically
switched from 4th to 2nd speed, after 6 minu-
tes operation.
If the appliance is working at 3rd speed, it is
automatically switched to 2nd speed, after 7
minutes operation. Operation speeds can also
be changed during operation.
The energy consumption of the appliance in
stand – by mode is lower than 0.5W.