Caple NOV800, Инструкция по эксплуатации, Страница: 7 / 12

7
WORKING
Mod. SL TC - Glass (dis. 16)
A: Light switch On/Off
B: Reduce speed / OFF motor
C: Luminous telltale
D: ON motor/incrase speed
E: 10 - minute timer
The touch control key allows the function desired
by touching the relative key.
If the electrical power supply to the product SLTC
is cut, 15 seconds are needed for selfdiagnostics
after the functions are restored.
In the meanwhile, its operation may be incorrect.
TIMING
As a result of the new EU65 “Energy label” and
EU66 “ Ecodesign” regulations issued by the
European Commission, which came into force as
from January 1st, 2015 , our products have been
adapted to comply with these new requirements.
All of the models complying with the energy
label requirements, are equipped with new
electronics including a timer device for suction
speeds control, when the air capacity exceeds
650m³/h.
Internal motor models, with maximum air capacity
higher than 650m³/h, are equipped with a timer de-
vice that automatically switches the suction speed
from 4th to 3rd speed, after 6 minutes operation.
The energy consumption of the appliance in stand
– by mode is lower than 0.5W.
An accurate maintenance guarantees good fun-
ctioning and long-lasting performance.
Particular care is due to the grase filter. It can be
removed by following the instructions below.
For the models SLTC110 and SLTC111 Touch
Control Version: The saturation of the filter is indi-
cated by the flashing speed indicators (Des. 16C).
Press the timer button to reset.
The grease filter needs cleaning by regular hand-
washing or in dishwashers ev ery two months at
least or depending on its use.
In case the appliance is used in its filtering ver-
sion, the active coal filter needs to be periodically
replaced.
To clean the appliance itself tepid water and neu-
tral detergent are recommended, while abrasive
products should be avoided.
The power cord shall be replaced by authori-
zed personnel only.
Substitution of the LED bar:
Using an appropriate tool, remove the LED bar
from its seat (refer to Fig. 17), disconnect it electro-
nically using the appropriate connector then sub-
stitute it with a LED bar with same characteristics.
MAINTENANCE