Caple JLWF302, Техническая информация

Страница: 19 / 24

13
5>.
Strip the ends of the wires, cut of the connect of new sensor and strip the ends of wires about
12mm , re-connect them .
Ensure this electrical joint is sealed against future water damage, and is electrically safe
Fix the wire in the correct position using the cable clip with screw
(Fig17& Fig17.1)
Fig.17
Fig.17.1
6 >
．
If the LED displays
”
E3
” ”
E4
”
, it indicates the sensor
“
E3
” ”
E4,
”
should be replaced the
anti-frost sensor under the evaporator (The replacement method is as same as below)
○
Since the location of sensor on the old model is difference, check the sensor as below
：
1 >
．
Normally the LED temperature display should the ambient temperature shortly after the unit
is plugged in, if not, disassemble the electrical box see
(Fig.18 & Fig.19)
, check if the sensor
plug marked
“
XI
”
connected properly, if this connection is made correctly and the fault
persists replace this sensor,