Caple di476, Инструкция по эксплуатации

Страница: 26 / 32

Positioning the
a
ppliance
How to
d
rain
ex
cess
w
ater
f
rom
the h
oses
If the sink is 1000
mm above
the floor, the excess water in
the
hose cannot be drained
directly into the sink. It will be necessary to drain excess water from hose into a bowl or
suitable container that is held outside and lower than the sink.
Water
o
utlet
Connect the water d rain hose. The d rain hose must b e co rrec tly fi tted to av oid wate r leaks.
En sure that the wat er inlet hose is not kinked or s quashed.
The following things should be checked before starting the dishwasher.
Syphon
c
onnection
Insert the drain hose into a drain pipe with a minimum diameter of 40mm, or let it run into the sink, making su
r
e
you
avoid bending or crimping it. The top of the hose must be less than 1000mm
above the floor
.
The content of this manual is very helpful to
all future
users.
After installation, please make sure
you
keep this manual.
Extension
h
ose
If you need a drain hose extension, make sure to use a similar drain hose.
It must be no longer than 4 metres; otherwise the cleaning
performance
of the dishwasher could be reduced.
1 The dishwasher is level and fixed properly
2 The inlet valve is open
3 There
is no
leakage at
any
connections
4 The wires are tightly connected
5 The power is switched on
6 The inlet and drain hoses are knotted
or kinked
7 All packing materials and printings
have
be taken out
of
the dishwasher
Position the appliance in the desired location. The back should rest against the wall behind it, and the side
s
along the adjacent cabinets or walls. The dishwasher is equipped with water supply and drain hoses that can
be positioned either to the right or the left sides to facilitate pro per installation.
21
Connect the cold water supply hose to a thr ead ed 3/4(inch) conn ector and make sure
that it is fastened tightly in place.
If th e water p ipes are new or have not been use d for an e xtended peri od of time, let the
water run to make sure that the water is clear. This precaution is needed to avoid
the risk of the water inlet
becoming
blocked and
causing
damage t
o t
he appliance.
Please
switch off the water supply after use.
Cold water connection
Starting the dishwasher