Caple DDMEXT2, Инструкция по эксплуатации

Страница: 4 / 8

Warnings!
- The air outlet of the appliance must not be connected to a flue which is used for exhausting
other fumes from appliances, such as a central heating, boilers etc..
- Ensure the external exhausting of the fumes, comply with the regulations in force.
- Ventilate the room suitably according to the laws in force when the appliance is working to-
gether with gas, oil or coal burning appliances, at the same time.
- The motor of the peripheral exhausting group is powered by the cookerhood placed in the
kitchen.
- Before connecting the cooker hood to the mains supply, make sure that the voltage indicated
in the rating plate corresponds to the mains voltage in the home.
- Before carrying out any sort of maintenance or cleaning operation, make sure that the ap-
pliance is disconnected from the electrical mains.
- Appropriate maintenance ensures
good working and good performance in the long
run.
Advice for good performance of the appliance:
- Use an exhausting pipe with the necessary minimum length.
- A few bends with a maximun 90° bending angle.
- Materials in accordance with the directives.
- Avoid any drastic change in the section (constant diameter: ø 150 mm. advised)
- Read the mounting and operating istructions of the exhausting cookerhood carefully.
- The manufacturer cannot be held responsible for a decrease of the air flow or for an increase
of noise level caused by non-compliance with the instructions above.
Warning!
The the
DDMEXT2
suction centrals can be connected to any other products from the
same manufacturer if they are equipped with the External Motor version.
In case they are connected to products from other suppliers, the SCET-1 central unit can
command them.
The manufacturer cannot be held responsible for damages caused by a incorrect use. No
garantee or indemnity will be due.
4
GB