Instruction manual C847i
24
Please keep this instruction manual for future reference
B E F O R E I N S TA L L I N G T H E H O B, M A K E S U R E T H AT:
-
The work surface is square and level, and no structural members interfere with
space requirements.
-
The work surface is made of a heat-resistant material.
-
If the hob is installed above an oven, the oven has a built-in cooling fan.
-
The installation will comply with all clearance requirements and applicable standards
and regulations.
-
A suitable isolating switch providing full disconnection from the mains power supply is
incorporated in the permanent wiring, mounted and positioned to comply with the local wiring
rules and regulations.
-
The isolating switch must be of an approved type and provide a 3mm air gap contact separation
in all poles (or in all active [phase] conductors if the local wiring rules allow for this variation of
the requirements).
-
The isolating switch will be easily accessible to the customer with the hob installed.
-
You consult local building authorities and by-laws if in doubt regarding installation.
-
You use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for the wall surfaces.
A F T E R I N S TA L L I N G T H E H O B, M A K E S U R E T H AT:
-
The power supply cable is not accessible through cupboard doors or drawers.
-
There is adequate flow of fresh air from outside the cabinetry to the base of the hob.
-
If the hob is installed above a drawer or cupboard space, a thermal protection barrier is installed
below the base of the hob.
-
The isolating switch is easily accessible by the customer.
B E F O R E L O C AT I N G T H E F I X I N G B R A C K E T S :
-
The unit should be placed on a stable, smooth surface (use the packaging).
-
Do not apply force onto the controls protruding from the hob.
