5
INSTRUCTIONS FOR THE INSTALLER
INSTALLATION
Installing the top
The appliance is designed to be embedded into
heat-resistant pieces of furniture.
The walls of the pieces of furniture must resist a
temperature of 75°C besides the room one.
The equipment must not be installed near
inflammable materials, such as curtains, cloths, etc.
Make a hole in the top of the piece of furniture,
with the dimensions indicated in fig. 3, at a
distance of at least 50 mm from the appliance
border to the adjacent walls.
MODEL
L (mm)
P (mm)
C739G
560
480
C759G
700
480
C769G
860
480
Any possible wall unit over the cook-top must be
placed at a distance of at least 760 mm from the
top.
It is advisable to isolate the appliance from the
piece of furniture below with a separator, leaving
a depression space of at least 10 mm (fig. 4).
If the hob is going to be installed on the top of an
oven, precautions must be taken to guarantee an
installation in accordance with current accident
prevention standards. Pay particular attention to
the position of the electric cable and gas pipe:
they must not touch any hot parts of the oven.
Moreover, if the hob is going to be installed on
the top of a built in oven without forced cooling
ventilation, proper air vents must be installed to
guarantee an adequate ventilation, with the lower
air entering with a cross section of at least 200cm
2
,
and the higher air exiting with a cross section of at
least 60 cm
2
.
Fastening the top
Every cook-top is equipped with a special washer.
A set of hooks is also supplied for mounting the
cook-top.
Depending on the type of mounting surface, the
suitable type of mounting hook is supplied (hook
A or hook B).
For the installation proceed as follows:
-
Remove the racks and burners from the top.
-
Turn the appliance upside down and lay the
washer S along the external border (fig. 5).
-
Introduce and place the cook-top in the hole
made in the piece of furniture, then block it with
the V screws of the fastening hooks G (fig. 6).
Installation room
This appliance is not provided with a device for
exhausting the products of combustion. Therefore,
it is necessary to discharge these smokes outside.
The room where this appliance is installed must
have a natural air inflow, so as to ensure a
regular gas combustion and room ventilation the
necessary air volume must not be lower than 20
m
3
.
Air must come from permanent openings made
on the room walls that communicate with the
outside.The section of these openings shall
correspond to at least 200 cm
2
.
FOR THE U.K. ONLY
The room containing this hotplate should have an
air supply in accordance with BS 5440: Part 2: 1989.
-
All rooms require an openable window, or
equivalent and some rooms will require a
permanent vent a well.
-
For room volumes up to 5 m
3
an air vent of
100cm
2
is required.
-
For room volumes between 5 m
3
and 10 m
3
an air
vent of 50 cm
2
is required.
-
If the room is greater than 5 m
3
and has a door
that opens directly to the outside, then no air
vent is required.
IMPORTANT NOTICE:
THE OPERATIONS INDICATED BELOW MUST BE FOLLOWED BY QUALIFIED PERSONNEL
EXCLUSIVELY, IN CONFORMITY WITH THE REGULATIONS IN FORCE.
THE MANUFACTURING FIRM REFUSES ALL RESPONSIBILITY FOR DAMAGES TO PEOPLE,
ANIMALS OR THINGS, RESULTING FROM THE FAILURE TO COMPLY WITH SUCH PROVISIONS.
