Caple C232SS, Инструкция по эксплуатации

Страница: 30 / 32

30
GENERAL
– The connection to the electrical network
must be carried out by qualified person-
nel and must be according to existing
norms.
– The appliance must be connected to the
electrical network verifying above all that
the voltage corresponds to the value
indicated on the specifications plate and
that the cables section of the electrical
plant can bear the load which is also
indicated on the plate.
– If the appliance is supplied without a
power supply plug and if you are not
connecting directly to the mains, a stan-
dardized plug suitable for the load must
be fitted.
– The colours of the wires in the appli-
ance power cable may not correspond
with the colours marked on the termi-
nals of your electrical plug. The plug
should always be wired as follows:
●
connect the green/yellow wire to the
terminal marked with the letter E or
the earth symbol or coloured
green/yellow;
●
connect the blue wire to the terminal
marked with the letter N or coloured
black;
●
connect the brown wire to the ter-
minal marked with the letter L or
coloured red.
The connection of the appliance to
the grounding unit is mandatory.
The manufacturer declines every
responsability for any inconve-
nience resulting from the inobser-
vance of this condition.
Electrical section
1111
Before effecting any intervention
on the electrical parts the appli-
ance must be disconnected from
the network.
– The bi-polar plug must be connected to
an outlet connected to the grounding
unit in conformity to security norms.
– If the oven is to be connected directly to
the mains, it must be placed with an
omnipolar switch with minimum opening
between the contacts of 3 mm between
the appliance and the mains.
– The power supply cable must not touch
the hot parts and must be positioned so
that it does not exceed 75°C at any
point.
– Once the oven has been installed, the
switch or socket must always be acces-
sible.
– If the power supply cable is damaged it
must be substituted by a suitable cable
available in the after sales service.
N.B. For connection to the mains, do
not use adapters, reducers or branch-
ing devices as they can cause over-
heating and burning.
If the installation requires alterations to
the domestic electrical system call an
expert.
He should also check that the socket
cable section is suitable for the power
absorbed by the appliance.